Turbo SSBP GSR: IT'S ALL DONE!!!
- Thread starter GSROWNSU
- Start date
GSROWNSU
New Member
Engine is not stock. Je pistons (comp ratio 9.6:1)...all new oem rod and main bearings (all blueprinted)...balanced crank...bored to 81.5mm with a fresh hone..all new gaskets and seals, cometic head gasket, arp head studs, and a hondata intake manifold gasket
CortezBanks
New Member
sexy as hell. Looks Amazing
hondahead_dave
New Member
That shit is tight, good luck and stay away from tickets.
DA_Integra
Not White, Pearl White
Congrats on finishing the car looks sweet can't wait to boost mine.
1caintegra
type-s and the RS
sleeper nice i wanna see some numbers
GSROWNSU
New Member
****Car is all tuned****
Had a problem with the 4 bar map sensor allowing more boost than 11psi with the s200 system. I guess the s200 system doesn't read the new 4 bar map sensors, only hondata s300 works with them. And the shop didn't have any gm 3 bars in stock. So the car was tuned off the wastegate at 10 psi. The official numbers are 313 whp and and 227 ft lbs of torque to the wheels! I'm very happy with the setup and yes the car is insane. I will be going back for a re-tune at a higher boost level once they get the gm 3-bar in stock!
Had a problem with the 4 bar map sensor allowing more boost than 11psi with the s200 system. I guess the s200 system doesn't read the new 4 bar map sensors, only hondata s300 works with them. And the shop didn't have any gm 3 bars in stock. So the car was tuned off the wastegate at 10 psi. The official numbers are 313 whp and and 227 ft lbs of torque to the wheels! I'm very happy with the setup and yes the car is insane. I will be going back for a re-tune at a higher boost level once they get the gm 3-bar in stock!