R13's 97 Gs-r Build thread

DonJulio

Reppin' tha NW
I gangster lean to the right when I drive. My elbows always on my center console. I can't use enhancements.
 

R13

The other asshole
Is there something to grease in the trans that would make a squeaking noise on deccel and clutch disengagment?

It sounds like the main shaft or clutch fork is dry everytime I push in the clutch or roll really slow.
 

MiketheDyke

My job is clean toilets
No update/pics...*leaves*

Lol, sorry Kurt, I'm no help :(
 


96LSteg

Jemel
Is there something to grease in the trans that would make a squeaking noise on deccel and clutch disengagment?

It sounds like the main shaft or clutch fork is dry everytime I push in the clutch or roll really slow.
When I had squeak on clutch disengagement it was due to the throw out bearing going bad. When I replaced the clutch that bearing came with it so it got replaced. Squeak went away.
 

R13

The other asshole
That's possible too, When the car is cold the clutch will engage kinda hard for the first couple of shifts, Like the bearing isn't moving freely.
 


96LSteg

Jemel
That's possible too, When the car is cold the clutch will engage kinda hard for the first couple of shifts, Like the bearing isn't moving freely.
I would say its bad then.

Know what this means right? Drop that trans and replace that clutch :lol:
 

R13

The other asshole
Buy RC51 then do it cause I'm pretty sure both axles will fall apart if I remove them :lol:
 

Nick_C78

New Member
Yeah I agree, it is the throwout bearing, which yes, you should just do the clutch while you are in there. Exedy OE replacement is an inexpensive route to take.
 

R13

The other asshole
Yeah it's a pretty cheap job, Unless it fails I'll just roll with it until I got my bike then I'll go from there.

$200 goes a long way towards a 4k bike and 1k worth of riding gear.
 

R13

The other asshole
Don't worry, I only spent $13 on the dip, The black was peeling off 2 wheels.
 
Top