Car alarm question.

johnownsall2

New Member
What colors go to one another? i have 2 orange wires red white gray green and one more i dont remember but well atleast the mess is gone and it shouldnt be that hard to get it fixed i mean if i cant get it ill hook up a wire to the starter and a wire to the battery run it to my car connect to a switch everyime i wanna start it flip the switch then when it starts just turn it off and ittl start right up but i rather seeif i can get the starter to work with out doing that
 

johnownsall2

New Member
Ok i understand all you guys said that and stuff but i dont have it on the road and i wanna do it bymyself i want to be an automechanic when i get older nad i wanna do all this by my self and its not that hardto fix it if it is ican jhust put a wire to the starter run it to the car then one from battery run it to car then run it to a switch and then call it a day until inspection is up but what would be the correct way to do this. i have two orange wires i have red green gray white black and few others which wires do i connect?
 

tisguy

New Member


When you install the alarm you basically cut into a wire, and each end goes into the alarm. To undo it, you just disconnect the brain (which you've done), and reconnect the disconnected wires.
 

johnownsall2

New Member
Actually everyone i got it workin t starts right up no problem now i connecected to orange wires and two green dissconnected a wire that went to the ignition wires i guess idk and it starts beautiful so for future preference it is not hard at all to remove a simple alarm just cut the wires that were connected to the stock wires or what ever then connect them and then tape it up and your good thanks alot guys really apperiate it :) now i just got a few oter problems such as drives side seatbelt wont move its automatic but dont move dome light and hazards
 


You must log in or register to reply here.
Top