b20vtec MFer
Member
alright cool, thanks a lot for your help! i really appreciate it
just ordered my koni/gc set
just ordered my koni/gc set
b20vtec MFer's 95 LS build thread
- Thread starter b20vtec MFer
- Start date
b20vtec MFer
Member
So..ran into some money issues and was gone for awhile but i finally got my Koni/GC setup on and i have the front dumped and thats all fine and dandy but ran into an issue when going to lower the back (to avoid unwanted wear)..well.. long story short it appears the car was in an accident along the right rear tire and the entire lip over the tire is about 30lbs of bondo >.< so i have one THICK unrollable fender in my way...its about an inch or more thick...any ideas on how i should overcome this??
myxintegra
Extreme Music Addict
Don't know dudde... sounds like you are in a very tight rut. Did you not adjust the shocks to a safer setup in the first place? :shock:
b20vtec MFer
Member
the back is sitting nice and high at the moment till i figure out how to work around this problem. look like a hot rod a little at the moment haha
its what all the cool kids are doing these days
its what all the cool kids are doing these days
myxintegra
Extreme Music Addict
apparently so... but too aggressive can cause a cascade of issues :lol: I'll keep that in mind when I go for my koni/gc combo. what were your spring rates on the springs?
b20vtec MFer
Member
whatever the stock spring rates are shipped from the clubintegra store? i don't remember cause they were sitting around my house for a couple months before i got a chance to put them on and now that they on i got this fender problem to deal with
myxintegra
Extreme Music Addict
Oh then they were 380 front 250 rear, did they ride soft?
Samurai_Blue
Yolo Whippin'
nope well kind of ive had problems kind of
stock is fine ish you know my rates. You know what rates i suggested you
b20vtec MFer
Member
yeah i would definitely listen to samurai. i am but yet a peon
BUT! anyone got any suggestions about my situation?
BUT! anyone got any suggestions about my situation?
Samurai_Blue
Yolo Whippin'
new quarter pannel
b20vtec MFer
Member
besides that -.- that would be my last resort
Samurai_Blue
Yolo Whippin'
roll the fender and rebondo it. it really depends on where the bondo is. i rolled mine and i was hit in the quarter pannel and no bondo cracked
myxintegra
Extreme Music Addict
he said it's unrollable though :suprise:
Samurai_Blue
Yolo Whippin'
unrollable because its physically unrollable or in fear of cracking bondo? bondo comes off with a flat head and a hammer