MrDB1integra
honda greaser
The wire that goes in the clip thats on the speedo gauge is not connected. How can I connect it?
Speedometer question
- Thread starter MrDB1integra
- Start date
gugiey
New Member
If the problem is what you say the wire came out of the clipThe wire that goes in the clip thats on the speedo gauge is not connected. How can I connect it?
then you would eather crimp it back in the clip or sauder it if that what was holding it befor
guiltyxxspark
Internet Hate Machine
Pull the cluster out and put it back in.
MrDB1integra
honda greaser
Well it is lol. Thats how I figured it out. Its just not staying in.pull out the cluster -_-
BrokenTalon27
W.F.O
Maybe it's run from the trans to the cluster wrong and there isn't enough length.Well it is lol. Thats how I figured it out. Its just not staying in.
Killahinteg
New Member
Fix the cluster
BrokenTalon27
W.F.O
When I did my motor swap on my 91 the speedo came out of the trans because I had ran it over something when it was supposed to go under it. Sounds simple, but sometimes that's all it is.I didn't think that you could run it wrong.
However there should be a clip to hold it on the cluster. Right?
BrokenTalon27
W.F.O
You are correct, but there are a few things in it's way, so you have to thread it in the right places as to allow enough slack for it not to pull out.Maybe mine is different? From what i'm pulling out of my memory, it comes out of the fire wall and basically has no where to go but straight to the transmission. There is a little metal thing it attaches to, but that's about it.