Wiring horn in quick release !

[Smartin]

So I installed my NRG quick release & hub 2 days go but idk how to wire the horn . I have a 95 integra RS . Can anyone plz help ?

 

[Samurai_Blue]

tap the horn button to the hub

 

[ChrisTypeR408]

http://www.honda-tech.com/showthread.php?t=2402541

Find the plug in that tutorial, run a wire from it on to a metal clip and put it behind the hub. Then wire your horn to the hub accordingly and you should have a working horn. It's not really as hard as people think...

 

[Smartin]

Thanks guys . This gave me a better idea on wiring the horn . The only problem is that I can't locate the wire for the horn . The only wires I saw were the 2 wires attached to the SRS spindle and the SRS spindle had this tape like thing attached to which was connected some where beneath the the whole set up . In order to remove the SRS spindle I had to cut the (electrical) tape . The SRS spindle has a yellow harness & a black one .

 

[BeatBox]

you found the horn right? should have two wires running to it or just one like MY teg.

i recently installed some Hella Horns in mine. just cut the stock wires inch and a half before the plug to the stock horn and wire to the new horn

hope that helps

 

[Smartin]

Nah dude : \
I can't find that damn wire for the horn . On the NRG quick release tutorial it says to disconnect the harness the SRS spindle is attached to . But mine did not have one . It has this electrical tape & I had to cut it I order to remove it . I'll try to take pics to show you guys what I mean : /