need some guidance lol

[Noelito23]

Ive always wanted a teggy, got it and im loving it! my dad used to have a 1st gen,i finally i bought a 97' teggy gs, with a b81a1 in it, it doesnt have any issues its just slow lol and not low either.

need some advice/help if i should swap a gsr in it, or b16 head, ive been doing my homework somewhat lol.
i been in the game for a little over a year :| lol

also wondering im not too sure what to go with for suspension. i read and seen around for spring/strut combos vs full coils.

i was thinking Koni Yellow sport with Ground control, or SK2 ProS II Coils, maybe even F&F since they can be dumped. spending wont be an issue im just not looking at over a grand right now
This would be my first set also, im currently riding on stock strut/spring that squeak like a b**** lol 190k+ miles on them i just replaced the tie rods joints n did an alignment so shes good now and starting with treating her with a nice slammed look for christmas.

any ideas advice help lol anything is better then nothing, what you guys think:lol:

 

[Samurai_Blue]

koni gc

 

[Local]

I enjoyed my buddy club n+ when I had them, they're a nice entry level coilover. I believe apexi also makes a good coilover.. Could be spacing on the name but I believe it's them. Koni + GC as mentioned above is also one of the best, tried & true; not a full body coilover tho. I personally prefer them over spring & shock combos.

 

[dcteg859]

Drop a b20 in it honestly if u just put a lightweight flywheel and stage 1 clutch with Gsr or b16 Trans it be a differ car. As far as getting low. Function and form one peices and skunk2 or function lcas do it the right way. I had a eg that was 2" off ground from lowest point on car not bumpers and it rode like a caddy stay away from blox lcas they have rubber bushings and blow out easy. I blew a set in a week

Sent from my M865 using Tapatalk 2

 

[Noelito23]

Drop a b20 in it honestly if u just put a lightweight flywheel and stage 1 clutch with Gsr or b16 Trans it be a differ car. As far as getting low. Function and form one peices and skunk2 or function lcas do it the right way. I had a eg that was 2" off ground from lowest point on car not bumpers and it rode like a caddy stay away from blox lcas they have rubber bushings and blow out easy. I blew a set in a week

i heard of that one before might look into that, i got blackworkks lcas

 

[dcteg859]

F%f are 650 I think as long as lcas has polyerathane bushings your good when you do it coat the lca and shock bolts in plenty of anti seize use lots of it they will never freeze again

Sent from my M865 using Tapatalk 2