endo617
Rattle Can Technician
man let me know if you find it
Looking for this everywhere
- Thread starter endo617
- Start date
biya
New Member
Well if there is demand on this pipe like I said I can fab it no prob. Just preliminary estimates I'm figuring around a ben a piece... but the price could drop if i could justify making enough to justify a jig,,,I need that same pipe! Lol
endo617
Rattle Can Technician
where you located, lol i hate asking my dad for stuff, never here the end of it hahaWell if there is demand on this pipe like I said I can fab it no prob. Just preliminary estimates I'm figuring around a ben a piece... but the price could drop if i could justify making enough to justify a jig,,,
biya
New Member
LMAO! I understand completely man... my fathers the same way.. you get them to help then they feel like they did it all or you owe them something... especially if your pops like mine and always wants to help but then holds it over your head if you let them...where you located, lol i hate asking my dad for stuff, never here the end of it haha
Anyways I'm in Hagerstown MD. kinda a trek from where you have listed as your town but I do top notch work... trying to get into aviation fabrication if that gives you a hint on quality.
endo617
Rattle Can Technician
:thumbs up i was looking for this so i can buy it when my builds gets closer to being finished, i'll PM you when i get closer, right now its in the back burner too cold out and lack of founds because of my daily(integra)LMAO! I understand completely man... my fathers the same way.. you get them to help then they feel like they did it all or you owe them something... especially if your pops like mine and always wants to help but then holds it over your head if you let them...
Anyways I'm in Hagerstown MD. kinda a trek from where you have listed as your town but I do top notch work... trying to get into aviation fabrication if that gives you a hint on quality.
biya
New Member
LMAO! I made a radiator fitting out of pvc for my v8 swapped zr2 a while back... hot antifreeze and pvc dont mix... chalk that one up to "learning the hard way". PVC would probably work for what the op is trying to do but judging by what he is looking for in appearance i would say he would find it unacceptable.pvc pipe
biya
New Member
No problem man, but ill just warn you if work in the shop picks up i wont be able to hold true to my "at cost" promise.:thumbs up i was looking for this so i can buy it when my builds gets closer to being finished, i'll PM you when i get closer, right now its in the back burner too cold out and lack of founds because of my daily(integra)