IntegraGuy Has a New Whip!! 2004 Acura TSX

Integraguy04

CORNER CARVER
So after 5 hours and having to cut almost every bolt off - the header is in.

Guess that's what I get for working on a stock car with 130.000 miles that has never been touched lol


Sent from my iPhone 4S
 


Integraguy04

CORNER CARVER
how does it sound? any definitive butt dyno numbers?
Well it sounds pretty raspy with the stock exhaust but its not that bad

I will be doing a dyno run here in the next couple of weeks with my reflash so I will post that up when I get the results..I'm hoping to be between 190-200


Sent from my iPhone 4S
 

Integraguy04

CORNER CARVER
**** UPDATE...GOT THE DYNO RESULTS ****

So I got back this evening from King with dyno results - and I was very pleased.

Here is a run down of the graph:

Blue Line - stock motor w/CT icebox, Hondata IM gasket, modded stock exhaust
Green Line - same as above but added PLM header with Test Pipe
Red Line - Same as green line but with Hondata Reflash.

If you look right at 6K - I gained over 40whp from the blue to the red - and it can be felt in the car big time - I highly recommend these mods they do a boatload to the car - make it feel much more responsive and just pulls harder.



Comments welcome.........
 

Smackinassvtec

New Member
**** UPDATE...GOT THE DYNO RESULTS ****

So I got back this evening from King with dyno results - and I was very pleased.

Here is a run down of the graph:

Blue Line - stock motor w/CT icebox, Hondata IM gasket, modded stock exhaust
Green Line - same as above but added PLM header with Test Pipe
Red Line - Same as green line but with Hondata Reflash.

If you look right at 6K - I gained over 40whp from the blue to the red - and it can be felt in the car big time - I highly recommend these mods they do a boatload to the car - make it feel much more responsive and just pulls harder.



Comments welcome.........
nice numbers! time to hit the tracks and see your quarter mile times now
 

OneFastGSR

Member
PLM header with test pipe added 15 whp before tune!? That's crazy I never seen actual dyno results of one of them. Good job!
 

Integraguy04

CORNER CARVER
Havent posted here in a while but just wanted to give a few updates...

After going through 3 sets of autozone rotors warping (i had a warranty so why not) i finally decided the hell with it and got some good quality pads/rotors...

see below RB Rotors and RB 300 series pads...






My Fiance also got me weathertech window visors for my B-day....

 
Top