DIY: another door insert thread!
- Thread starter ixcocoyxi
- Start date
Sammich
Active Member
horrible screws that's possibly gona result in my breaking the plastic handle 'shrouds' to remove the screws. have to find some first before i pull the panels
covert_Con
Senior Ricer
I have some plaid fabric I need to try this with, it's a little thin but I think it'll work.
ixcocoyxi
RS owner
i like that pattern! if i found that, i prolly wouldve used it.All I need to do is cut them properly. They're on, I just never trimmed them.
yeah. just respray glue to where it came off.Any ideas on how to use the stock fabric again by any chance? I have the fabric on my db door panels that matches the ITR seats (tweed) and I cannot find anything that matches. Looks like I have some itr sedan panels
Sent from my Glade Air Freshener using Tapatalk.
g3teg97
Super Moderator
knew it 8)
MrGurley
************5-0
haha heck yea!! I think that would look killer!! once I paint the car! cant roll around looking like a packers fan!!
Last edited:
XslickwhitetegX
UKDM EXPERT
my gf finally got time to finish my panels. after i showed her this thread and coys car for inspiration
need itr rear seat bad, also have a wallet out of this material haha
need itr rear seat bad, also have a wallet out of this material haha
ixcocoyxi
RS owner
you could do what i did and use that fabric spray paint they sell at pepboys/autozone to make the gray seats black.my gf finally got time to finish my panels. after i showed her this thread and coys car for inspiration
need itr rear seat bad, also have a wallet out of this material haha
this is the closest pic i have of the rear seats.
for best results using the spray
-vacuum
-spray
-let dry
-bursh fabric with stiff (plastic) bristle brush
-vacuum
did it to all my seats.
Sent from my Glade Air Freshener using Tapatalk.
ixcocoyxi
RS owner
i had a friend with an ef sedan donit to his blue seats to match his jdm black ones with the mesh headliner
Sent from my Glade Air Freshener using Tapatalk.