Accord/Prelude engine swap

[DaddyBuiltRacing]

Onew problem, he makes no mention of how much the h2b conversion cost, you gotta figure that in, theres another grand. He also doesn't mention how much he had in machining cost..

Why not just go H22 and make the same power with simple bolt ons and be more reliable? For some reason the H series is a forgotten motor that gets no love, Endyn made over 300whp NA on an H22

 

[hgocasca]

Or take your ls, boost it for less and get more!

 

[DaddyBuiltRacing]

^^ That too. Im not trying to come off as a dick, but this motor setup is a abomination. Someone that was really bored and blew up a couple motors decided to slap the remaining good parts back together. The funniest thing is why would you even want an h22 head over the F series? The F series head are the best flowing heads outside of K, why do you think Bisi swears by them

 

[hidenplanvew]

H22 head on a F22 block is so you can use forged pistons instead of buying a sleeved block.... Its a "cheaper" way to go... But the crank he uses in the g23 is a f23 crank its a 97 or something stroke over the 95 stoke... Its a cool way to make something on the cheap to make some decent power. To say the parted together motors arnt as reliable as a stock motor wouldnt be compleatly true. I have seen motors of both types fail.. one you change anything from stock you make it "Unreliable".

 

[DaddyBuiltRacing]

So your saying you can't run forged internals in a stock sleeved all motor h22? Interesting...

But you are right the f23 does have a 2mm bigger stroke, my bad. Like I said in a previous post, why not just do an F20b? Look at the specs

210 HP @ 7200RPM
145 TQ @ 6600RPM
147.10 kW
11.0:1 CR
85mm bore
88mm stroke
23mm wrist pin
145.5mm rods (f20b rod length = 145.425)
1.65 r/s ratio
55mm mains like h22a4 block


Its a more reliable "g" series, your getting the F series block with an H series head pretty much. Not to mention the shorter stroke will allow the motor to rev out quicker compared to a long stroke motor. The loss of tq isn't really that noticable, its still more then a B series makes stock lol

 

[hidenplanvew]

Ya... If I had the junk just laying around I would try it just to see if it would even start let alone drive...