1-30-09 photoshoot

[Samurai_Blue]

your valve cover is covered in paint and separated from your motor with a rubber gasket. putting a ground there is useless. the oem spot is on the valve cover nut to the left of where it is now. it goes there since that stud is connected to the motor and will actually make a difference. i dont care if you leave it, its not an important ground and you probably wont even notice if no wire is there; however, it should be like this.:

my eyes went from -_- to :shock: when i saw that motor

 

[Sammich]

Also i was reading in a super street magazine about cleaning up your engine bay, and it said you can ground it to the back of the VC somewhere. Is there a certain spot i could put it back there?

PRETTY SURE U CAN BOLT IT TO ONE OF THE BOLTS ON THE BACK OF THE VC TO THE FIRE WALL

 

[g3teg97]

Love that color.