the right "stance"?

[tork_sd89]

I'm having some problems getting the right look with my skunk 2 pro-s 2 coilovers. I think the rear looks too low when compared to the front. I've raised the rear twice and thought about dropping the front more but i barely make it into my driveway now lol How do you think it looks from the pic? In person it looks even but up front i have about a 2 finger gap and in the rear i have a 1 finger gap after raising it more yesterday. The rims and tires should be in this week.. not too sure how much of a difference that will make but i think i need to go up in the rear at least another 1/2 an inch. It's been hard for me to get the car just how I want it because this is the first pair of full coilovers i've owned and I wasn't sure how to adjust them

I want my teg to sit a little higher in the rear like this:

 

[Ominous G2]

That's called rake, and I think the ass could go up a little.

 

[tork_sd89]

yea cuz right now it looks like i killed this bitch and stuffed the body in the back of the hatch

 

[Ominous G2]

I had the same problem, doesn't look as good flat or high in the front.

 

[tork_sd89]

it was worse! lol I looked like a low rider before but then we dropped the front more and raised the rear some more but it still needs to go up more.

 

[BeatBox]

mine has the same deal going on, higher on the front than the rear....only solution drop the front IMO

 

[Jvest]

I think it looks really good how it is but it's All personal opinion so in the long run it's up to you. Also if u don't have a camber kit in the rear it will cause this due to the negative camber.
Btw car looks clean!!!!

 

[meANDmyDB7]

i'm not saying this is a solution, but why won't you try raising the back significantly higher and then see from then on? kind of like restarting everything but the installation of the coilover set.

 

[tork_sd89]

I think it looks really good how it is but it's All personal opinion so in the long run it's up to you. Also if u don't have a camber kit in the rear it will cause this due to the negative camber.
Btw car looks clean!!!!

uh oh lol yea i don't have a camber kit yet and I didn't get an alignment because the tires are already toast and my and new tires will be on this coming week so i planned on doing the alignment then. and thanks man!

 

[tork_sd89]

i'm not saying this is a solution, but why won't you try raising the back significantly higher and then see from then on? kind of like restarting everything but the installation of the coilover set.

I'll try this... It gets hard to move the shock body tho while the coilover is still on the car. I might have to un-bolt it from just the LCA to make it easier. thanks

 

[superhypered]

mines the other way around, the front is lower than the rear, in case someone fat is sitting in the back, I wont rub. haha

 

[Ominous G2]

mine has the same deal going on, higher on the front than the rear....only solution drop the front IMO

You have 1,000lbs of stereo in the back, I'd expect that. :lol:

 

[BeatBox]

You have 1,000lbs of stereo in the back, I'd expect that. :lol:

hahaha right now actually, with all that junk its higher in the rear than in the front, i put accord H&R fronts springs in the rear its better off than when i didnt have anything