Godspeed suspension????

[Samurai_Blue]

i have no idea what you are talking about then because the progress and godspeed coilover and the function form and all other suspension companies use perches on which the spring rests on. you screw the perch down to lower it which shortens the overall height of the coilover when its on the ground causing your car to be lowered. this shortens the shock travel within the coilover. Its better on a full coilover than a coilover sleeve as struts are not made to be lowered that much.

 

[teggyboi59]

i have no idea what you are talking about then because the progress and godspeed coilover and the function form and all other suspension companies use perches on which the spring rests on. you screw the perch down to lower it which shortens the overall height of the coilover when its on the ground causing your car to be lowered. this shortens the shock travel within the coilover. Its better on a full coilover than a coilover sleeve as struts are not made to be lowered that much.

Wat I mean is that Godspeed nd f&f1 u could lower the car ether with jst coilovers perches or Lower the whole shock down nd progress coilovers only lower by coilovers perches u know wat am saying or trying to say lol... look at pictures bro ull know wat am saying

 

[Samurai_Blue]

No i have no idea what you are saying.



But, on some coilovers you can move the shock up or down yes but its only little, about 20-30mmwhich isnt a big drop and most of the time thats so you can raise the car up as there is already thread which is down there thats how it is on function form, buddy club, megan etc

 

[Rich-PMS]

function/form are better than godspeed coilovers

 

[Kyle]

Well Progress recommends you don't go below 11.5inchs (distance from center of the axle to the top of the wheel well). I got my set at about 12 3/8. It comes out to about a finger gap and half both front and rear and I have alot more I can go. 12 inches and you'll be tucking. Progress arn't ment to be super sexy slammed so don't go with them if thats your plan. Go with Tein or FF. Not to mention they are made in the USA.

 

[teggyboi59]

Well Progress recommends you don't go below 11.5inchs (distance from center of the axle to the top of the wheel well). I got my set at about 12 3/8. It comes out to about a finger gap and half both front and rear and I have alot more I can go. 12 inches and you'll be tucking. Progress arn't ment to be super sexy slammed so don't go with them if thats your plan. Go with Tein or FF. Not to mention they are made in the USA.

Oh okay thx for the info bro.... ill definitely get the ff kus I want it slammed thx again bro...