Upgrade Question?

[lilsilverflip]

Whats the best engine upgrade you can do? Besides the normal bolt ons,while still being an all motor setup.
Right now i have DC headers, AEM CAI,Skunk2 Manifold..still looking for an exhaust. But what could i do to internals. Thanks

 

[thenoxus1]

Cams/rods/pistons etc, there are a lot of all motor builds on here, go check them out for some other ideas etc.

 

[heritage36]

I would start with cams and go from there, start with a mild cam upgrade like type R or skunk2 stage 1's or something.

 

[No Rice Riley]

yea get some skunk2 cams and gears, make sure to have them tuned, you could get a new performance chip too? simple stuff. if you build the top end you should freshen up the bottom end too

 

[Samurai_Blue]

yea get some skunk2 cams and gears, make sure to have them tuned, you could get a new performance chip too? simple stuff. if you build the top end you should freshen up the bottom end too

dyno tunes > chips

Dont forget some cams need a compression increase from pistons and get valvetrain stuff too

 

[WAR 178]

with those cams should go some springs,retainers,etc just like samurai stated above. also the dyno tune will be needed after! a real dyno tune >>>>>chips! a good tuner can squeeze power outta your stock setup as is!