what did you do to your car today?

jznsn2u

Active Member
^did you extend and solder your headlight harness?

I drove it in the rain and I drifted around cones, up and over a mountain.
 

jznsn2u

Active Member
Didn't need to, it fit almost perfect with a little extra wire, no issues :) saved a lot of time too.
Sweet, did you drill a hole near your brake booster and channeled the harness through there? Or did you retract the whole harness and squeeze it through the ruber piece where hood latch cable is?
 

klutchDb7

ლ(ಠ益ಠლ)
Sweet, did you drill a hole near your brake booster and channeled the harness through there? Or did you retract the whole harness and squeeze it through the ruber piece where hood latch cable is?
Retracted the harness and bored out the hole where that rubber piece was so it would all fit, then ran it up the inside of the chassis.
 

aiitownack

New Member
went outside to sand some more... immediatly realised i didnt feel like doing so, apologized to the car, rubbed her sideview mirrow while promising to finish it soon... then took my a** back inside to the fire. I think she understands.
 

djintegra

New Member
installed new axles and flushed the trans fluid. car wouldn't downshift into first or second before when the trans was cold. thought i was in for a trans rebuild but replaced the fluid with honda mtf and it completely fixed the problem. shifts smoothly into every gear no matter what the temp is. the old fluid looked and smelled kinda like diff/gear oil and was black as anything.

if you are having any hard/notchy shifting issues, i highly recommend honda mtf!
 
Top