How do i do this....?
- Thread starter Kinteg
- Start date
Rich-PMS
New Member
jznsn2u
Active Member
What size piping is your aftermarket catback exhaust?
1. Jack up car.
2. Set jack stands under for safety.
3. Unbolt old catback exhaust.
4. Install new catback exhaust.
^ That's basically how you replace an exhaust system after the catalytic converter.
The b-pipe size (after cat) is 2.0 for gsr/ls/se/rs/gs. If you're upgrading mid pipe size you may have to go to a muffler shop so they can weld on a piece that expands from after your cat, to your mid pipe.
1. Jack up car.
2. Set jack stands under for safety.
3. Unbolt old catback exhaust.
4. Install new catback exhaust.
^ That's basically how you replace an exhaust system after the catalytic converter.
The b-pipe size (after cat) is 2.0 for gsr/ls/se/rs/gs. If you're upgrading mid pipe size you may have to go to a muffler shop so they can weld on a piece that expands from after your cat, to your mid pipe.
Kinteg
Whoops
okay thanks, but...
How woul di tell if my stock exhaust system is actually a catback or is it just that way normaly?
jznsn2u
Active Member
Measure it. The diameter of a stock integra exhaust pipe should be 2.0 (non type r).
Kinteg
Whoops
Alright, Thanks
whatevrthefrag
New Member
i took it to my friends car college cause they do free installation on anything you bring in(its extra practice for them) except welding :evil:
although after i found on i dont have a stock cat, and its just not bolt on, i took it to a muffler shop and did it within an hour, shouldnt cost more than 60 bucks if anything.
Make sure you go there with the right exhaust system 4 your car.
hope it helps!