any one knows how to install a new shift boot ?

ixcocoyxi

RS owner
sure. its easy. remove the shift knob, the arm rest and the shifter plate. replace the boot, and thats it :thumbs up
 

DC Guardian

Uniqueness defines
i havent done it before, but i know the general idea is to take off the entire center console. look on yourutbe, theres some how-tos that can give you an idea

vvv or that?
 

Rich-PMS

New Member
My buddy ordered a boot from there- it was horribly done. Hope you have better results. If not, PM me, I'll make you a black boot with blue stitches :)

FYI- on gen2 you haveto take the underdash pieces off driverside and passengerside to get to the screws for center piece.
 

edwon01

New Member
My buddy ordered a boot from there- it was horribly done. Hope you have better results. If not, PM me, I'll make you a black boot with blue stitches :)

FYI- on gen2 you haveto take the underdash pieces off driverside and passengerside to get to the screws for center piece.
How much do u charge ? FYI I live in Vancouver bc and would u mind explaining how to I get the dash piece off?
 


navysailor956

New Member
Just did this yesterday, xcept i got a password JDM shiftboot. Neways on the passenger side, the panel under the glove box. Take the 2 screws on the left and right side and then the panel should then come off. Do the same thing on the driver side. * might have 2 take out ashtray, Just pull it. Then u can unscrew the center console. 3 screws on each side i think. Take ur shiftkob off and pull of the center console. under it theres a metal bracket held on by 2 screws holding the old shiftboot in place. take the bracket off, then udo the shiftboot from the bracket. The shift boot has some slits all the way around on the bottom of it, where it attatches 2 little tabs on the bracket. Attach ur new shiftboot, Put everything back 2gether and ur done.
 
Top