Edlebrock X manifold with what TB?

00GSRfullbuild

New Member
I was going to order the Edlebrock manifold for my soon to be boosted integra. But with turbo and a 65mm port on the manifold what size TB should i match to it for best flow and everything? I was thinking if i got a 66mm Tb and just did some real minor milling around the port mouth to match it that would maybe be best? Or should i raise to a 68 or even 70 mil TB? Thanks All
 

00GSRfullbuild

New Member
Well, the way i have my build going right now i am going for a max whp of around 500, not any more than that. I am using a 61mm trim i think it is Garrett T2/T61 "Blowzilla" turbo
 
Last edited:

00GSRfullbuild

New Member
Compressor Specs:
-GT35R 61mm compressor wheel
-0.70AR T04S compressor housing
- Flow Rate 65lb/min

Turbine Specifications:
-Stage 3 or 5 turbine wheel
-0.63 A/R. turbine housing available
-4 bolt standard turbine discharge
 


Samurai_Blue

Yolo Whippin'
i would say somewhere between 67-70mm is the magic number depending on how high you rev you may want the Victor x, some say its better for boost than NA
 

00GSRfullbuild

New Member
Yea thats the one i was looking at. AC and Venom both want somewhere around 600 bucks for there turbo log manifolds and i cant do that with all the money already being spent.

It has a 65mm port, so i was going to get my TB and then port match it. Would u say it would be better to just go with a 70mm rather than a 68? Because that pretty much what i am stuck between and i didnt want to have one thats to big, but obviously to small also.
 

Samurai_Blue

Yolo Whippin'
i think 70 you should be fine. Would you be port matching the entire thing or just the opening?
 


00GSRfullbuild

New Member
Maybe eventually the entire thing but for now just the port opening. So its smooth and not like the air is hitting a wall. I have to round off like 5mm out of the edlebrock to get it to 70.

Edlebrock sells a Tb in 70mm and its comes with a 1/2 in gasket and tps sensor that is already installed in the proper position for 300.
 

slowboyy

New Member
00GSRfullbuild said:
Maybe eventually the entire thing but for now just the port opening. So its smooth and not like the air is hitting a wall. I have to round off like 5mm out of the edlebrock to get it to 70.

Edlebrock sells a Tb in 70mm and its comes with a 1/2 in gasket and tps sensor that is already installed in the proper position for 300.
Click to expand...
get a victorx with a 70mm tb and call it a day i making 619whp over 358tq with that setup previous setup with out the cams and smaller turbo(30r) made 486whp 300tq with a r manifold with stock tb(67mm)
 

00GSRfullbuild

New Member
slowboyy said:
get a victorx with a 70mm tb and call it a day i making 619whp over 358tq with that setup previous setup with out the cams and smaller turbo(30r) made 486whp 300tq with a r manifold with stock tb(67mm)
Click to expand...
Damn dude thats nasty. I recieved the manifold, the TB should be arriving today or tommorrow :D Cant wait lol
 
You must log in or register to reply here.
Top