pepsilude
New Member
I know this is a pretty easy install but I'm sure this will help someone out since I haven't seen any good instructions.
This is Si-Vtec replica lip onto a 94-97 front end.
What you will need:
There are four pre-drilled holes where you shoot rivets through to hold the brackets in place. The two brackets that have a slant angle to them go on the tower outer holes.
Make sure you have the brackets facing this direction
Now there are four bolt holders that slide into pre-made notches in your bumper.
Insert the bolt holder
Now slide
While your looking under your car, check for leaks
Bolt the bracket to the holder
Since I was working by myself, this is how i held the lip in position
Now drill a whole through the lip and the bumper on both ends. Screw your screw. (haha don't know how else to say it)
YOUR EFFING DONE :lol:
This is Si-Vtec replica lip onto a 94-97 front end.
What you will need:
- Si-Vtec lip kit with included hardware
- Socket wrench
- 10mm Socket
- Rivet gun
- Jack (Not really need if you can fit your head under the car)
- Power drill and drill bit
- Screwdriver
There are four pre-drilled holes where you shoot rivets through to hold the brackets in place. The two brackets that have a slant angle to them go on the tower outer holes.
Make sure you have the brackets facing this direction
Now there are four bolt holders that slide into pre-made notches in your bumper.
Insert the bolt holder
Now slide
While your looking under your car, check for leaks
Bolt the bracket to the holder
Since I was working by myself, this is how i held the lip in position
Now drill a whole through the lip and the bumper on both ends. Screw your screw. (haha don't know how else to say it)
YOUR EFFING DONE :lol:
