Coupe back seat?

Accel.speed

basically, i like fast!
The middle plastic part in my coupe is pretty annoying... Does anyone know of a swap or something custom to change it to either cup holders or like a big armrest?
 

mikekh10a

New Member
honestly i have not seen any of that done.
the only options you have are to swap in EG rear seats...perfect fit..
the only other seats tthat fit in with none-little modification is the RSX as far as i know..not sure about EK...
but i think either the JDM or the integras in canada came with rear seats with nothing in the middle..i'll get back with taht

EDIT: yes its the JDM rear seats that have no middle peice..
 
Last edited:

Accel.speed

basically, i like fast!
Hmmm ok thanks. I think i might custom make something the will act like an armrest that sits in the plastic thing. This otta be interesting lol
 

.Cortez

94' LS
You may want to look into JDM ITR seats(rears) Ive seen them go for aslittle as 150$ and their sex...
 


ixcocoyxi

RS owner
jznsn2u said:
Fabricate some cup holder's or sew a pillow into it :lol:
Click to expand...
you could get some thick foam, carve it to fit on top of that plastic piece, and then wrap it in some kind of fabric. that's what i would do.. i might even do that.. if i ever decide on putting my rear seats back in..
 

bradster101

New Member
how do you take the seats out? I was looking at that the other day but nothing....
 


Accel.speed

basically, i like fast!
ixcocoyxi said:
you could get some thick foam, carve it to fit on top of that plastic piece, and then wrap it in some kind of fabric. that's what i would do.. i might even do that.. if i ever decide on putting my rear seats back in..
Click to expand...
Yeah thats a good idea. Get soem dense foam and carve it. Sounds fun too lol. Shouldn't be too expensive either. I'll be doing that when i get the time and some pocket money lol.

bradster101 said:
how do you take the seats out? I was looking at that the other day but nothing....
Click to expand...
It's really easy actually. Fold down one seat and look at where it pivots on the side on the car. Theres a black tab in the joint. Use a pair of plyers and pull it out. Then wiggle the seat at the joint in the middle of the car and pull the seat out. Same with the other seat. Then theres just bolt under it to get the bottum seat out. Unscrew that and take out the seat. You have to move it up and down a bit to get it out. Im sure you can figure it out if you just look at it. Its fairly easy. A monkey could do it XD. No worries though.
 
You must log in or register to reply here.
Top