Skunk2 intakes good???

horeks90

New Member
i was thinkin bout getting a skunk2 to intake manifold on my integra. i was curious if there any good and if they will improve hp and accel or anything?? also if you had to upgrade my cams or is stock fine??? thanks for any input

--------------------------------------------------------------------------------
 

tilegend

New Member
for a stock motor, no.
yes you would need more supporting mods before an intake manifold would be needed.
 

red98teg

Keep on Truckin
^as he said, putting on an aftermarket intake manifold will only hurt the performance of your stock motor. only after you have mods such as cams, springs & retainers, valves, high compression pistons will it be worth it. HOWEVER... a good port and polish can always free up a few extra HP
 

horeks90

New Member
red98teg said:
^as he said, putting on an aftermarket intake manifold will only hurt the performance of your stock motor. only after you have mods such as cams, springs & retainers, valves, high compression pistons will it be worth it. HOWEVER... a good port and polish can always free up a few extra HP
Click to expand...
how $much$ u guess port and polish would run? thanks a lot guys save me time and money :)
 


horeks90

New Member
heykosal said:
The point is to make the path of airflow smooth, don't take too much metal off, you're goal is to smooth out the ports.

Just a tip, because I think you should do it.
Click to expand...
did u do it? damn i could have done it to my exhaust ports when i put my header on. how much would it help?
 


sashlude

New Member
Port and polish and 1mm oversized valves and that intake will scream but your looking at a good 2,000 if you want it done right by a machine shop but they will also resurface your head just incase that may be warped something a naked eye can't see to well.
 
You must log in or register to reply here.
Top