Post a pic of your latest purchase.

[TeggyRussE]

Harbor Freight always has 20% discounts in every newspaper. Not only that, you can get free stuff without spending a penny. I do that, when Im in the area.
I know the Torque Wrench is $8 and it just gets cheaper from there.

Wish i had one at that time!!

Im in their "track club" and none of the things i bought were discounted...

 

[DCiFound]

Wish i had one at that time!!

Im in their "track club" and none of the things i bought were discounted...

Every car magazine has a harborfreight coupon page. Sometimes the newspaper has them too, but its rare. My dad gets mailed a coupon book every couple months.

Harborfreight is a one time use in my book. Ive had tools break, after using it a couple times. Or its cheap enough, where i use it just one time for a small job and get stashed away to never be used again :lol:

 

[Samurai_Blue]

I like have my spine held upright so it can be crushed inwards, got a seat and bracket.

you have a roll bar and a harness for that seat?

 

[Noneed2Hate]

you have a roll bar and a harness for that seat?

nope, that's next on the list though. Speaking of which how much should I be looking at spending for a legitimate basic 4 pts roll bar? I've seen some things online for like 2-300 dollars but those seem too good to be true. (I understand they'd still need to be welded etc)

 

[Samurai_Blue]

Im selling my green one for 500obo. But im not sure if it will fit with a sunroof.

 

[Noneed2Hate]

Im selling my green one for 500obo. But im not sure if it will fit with a sunroof.

sending you a PM

 

[jdmjim]

http://www.summitracing.com/parts/mpe-16828/overview/year/1978/make/chevrolet/model/camaro
cat back

 

[R13]

You have a '78 bromaro?

 

[94RS]

Oh no... Kert is about to redneck rage all over.

 

[R13]

No rage here, I like 2nd gen f-bodies.

 

[94RS]

No rage here, I like 2nd gen f-bodies.

Redneck rage because you got rid of yours...

 

[R13]

Mine was a piece of shit with blue/white interior, a peg leg diff and an autotragic trans, don't miss it at all.

 

[phatintegra]

nope, that's next on the list though. Speaking of which how much should I be looking at spending for a legitimate basic 4 pts roll bar? I've seen some things online for like 2-300 dollars but those seem too good to be true. (I understand they'd still need to be welded etc)

I bought my 4pt Autopower for around $200. Then another $250 to powdercoat it.

 

[jdmjim]

You have a '78 bromaro?

I do

I bet u don't know what that is,lol

 

[R13]

You old bastard :lol:

I like my username ya got there on your shift knob :mrgreen:

Also kinda jelly, manual trans 2nd gen f-bodies are hard as fuck to find.