what did you do to your car today?

[94RS]

How the hell do you cross thread a fuel filter...

 

[Noneed2Hate]

How the hell do you cross thread a fuel filter...

hell if I know. It was a cheap one.

 

[94RS]

The one I bought was a cheap one and came with all new shit... No excuses

 

[Accel.speed]

The one I bought was a cheap one and came with all new s***... No excuses

Can verify. I think mine was $12 and it went on like an oil filter...

 

[Noneed2Hate]

Well I ended up getting a new one again and this time it went on smoothly. No Fuel leak etc. I am quite happy

 

[DCiFound]

Suspension work and headlight swap. Feels stiffer and solid now, compared to the worn out oem bushings

I already done this arm. It was incomplete without this pic i took today

Old headlights

 

[SoundEfx]

I wish I had a garage half that size. Pimp on pimp, pimp on.

 

[DCiFound]

I do too. It was a buddies place. You shouldve seen it, before he cleaned it lol

And, i will ask around from the text you sent earlier. I was busy You posting reminded me heheh

 

[R13]

First you changed that trunk bar which was meh over the old one, and now you've changed to headlights that suck compared to the old ones...

 

[DCiFound]

What sucks about the new headlights? I had to change them anyways. The driver side has been building condensation. I was to lazy to reseal it after taking them apart. Already had to replace the ballast once, since they are on the bottom of the headlight, where water puddles up. Also, there were water streaks on the inside of the lens that started to get to me.

These headlights use 9006 bulbs. Didnt want to go HID with them, so im going cheap with Halogen. Philips Crystal Vision is brighter than i was expecting for Halogen.

 

[R13]

The sides with the amber part looks bleh

 

[DCiFound]

I went for the JDM YO! look. Havent said that phrase in a long time :rolf: Im still trying to get used to the beam spectrum. Used to seeing more of the sidewalk, now i see more of the cars passing me by

 

[jbrown97ls]

why a k tuned shifter? No aftermarket shifter is better than the stock integra one.

To make the build list look better, duh!

 

[DCiFound]

This wasnt today, but my ignition starter switch went out. The exposed copper was the problem. Also swapped for shorter nuts so i can fit the lug cover on

 

[DCiFound]

Finished the suspension and had the alignment done. Phase 1 is officially done. Now onto phase 2 with the engine gaskets/seal overhaul.

Installed rear spherical bearings into the spindle. What a PITA it was, since i never done it before. First side took about an hour, the other side was much easier and faster.

Old oem set is toast

This is the best tool for the job to remove and install bearings without removing the spindle

And just hit this tonight on my way back from the alignment shop 8)