Charlotte (Nicks 95 GSR)

[DCiFound]

I am planning to replace my inner and outer tie rods and have a question about your alignment. Did you mark the old tie rod to know where to place the new tie rods, or did you go in for an alignment afterwards?

 

[Nick_C78]

I will be getting another alignment, but I measured it too so its close. Almost impossible to explain where I measured without pics. Basically theres a groove that the front of the boot locks in to. I measure from that groove to where the outer tie rod threads on.

Just get an alignment, especially if its a daily.

 

[JustinMcGee1]

I am planning to replace my inner and outer tie rods and have a question about your alignment. Did you mark the old tie rod to know where to place the new tie rods, or did you go in for an alignment afterwards?

When I did mine, I counted the number of rotations it took to unscrew them, then spun it the same number of times getting them back on. Then went to get a front wheel alignment afterwards.

 

[Samurai_Blue]

time to go to west end

 

[DCiFound]

I will be getting another alignment, but I measured it too so its close. Almost impossible to explain where I measured without pics. Basically theres a groove that the front of the boot locks in to. I measure from that groove to where the outer tie rod threads on.

Just get an alignment, especially if its a daily.

When I did mine, I counted the number of rotations it took to unscrew them, then spun it the same number of times getting them back on. Then went to get a front wheel alignment afterwards.

Ok, thanks for the suggestions

 

[Nick_C78]

time to go to west end

Tuesday. Lol

 

[Integraguy04]

Nice to see the oil cooler. I have a Setrab as well and it's very nice

Sent from my SM-G900V using Tapatalk

 

[Samurai_Blue]

Tuesday. Lol

doing mine thursday fml...

 

[Nick_C78]

Nice to see the oil cooler. I have a Setrab as well and it's very nice

Sent from my SM-G900V using Tapatalk

19 row 6 series? How did you mount yours

 

[Integraguy04]

I made custom L brackets out of aluminum with some rubber insulator gasket on each side. Mine was a used one off of a NASCAR style car. I used like the radiator support in front of the bumper if I have pics I'll get them

Sent from my SM-G900V using Tapatalk

 

[Nick_C78]

Let me know when you get the pics.

 

[Samurai_Blue]

I thought he had one in his build thread already

 

[Nick_C78]

I found them. His cooler looks similar but the oil fittings are in different location

 

[Bitanga]

Looking good.

 

[LsTeg97]

Good job on your car. Its always looking better the more the race it