endo617: 98 Ej6 Project: Balanced Form

endo617

Rattle Can Technician
Alright, tires were swapped. Not much a stretch on them,and fit in wheel-well nicely. I forgot my valve stems at home, pretty bummed out about that but it's not like they had any performance applied to them.





 

endo617

Rattle Can Technician
I was going to buy new control arms but replacing bushings was only $8, plus budget is going to block rebuild.

 
Last edited:

endo617

Rattle Can Technician
Pull the trigger and going DIY big brake kit(BBK) in the rear. Just got these DC5 rear calipers that are going to be mated with 4x100 EP3 rotors.


 

endo617

Rattle Can Technician
OP was updated with new parts and plans.
 


R13

The other asshole
Your hood makes me want an extractor hood. :rice: :lol:

It works on your car though! Would look good on a jdm front too.
 

endo617

Rattle Can Technician
R13 said:
Your hood makes me want an extractor hood. :rice: :lol:

It works on your car though! Would look good on a jdm front too.
Click to expand...
I went full Ricer ;) Future color match is looking promising. It will look a lot better.
 


endo617

Rattle Can Technician
Just got a few parts I've been wanting. Still trying to decide what to do about this year's power-plant. It's either rebuild the GSR, buy a JDM engine, or get an LS transmission for now to go with my current B20B and save some proper cash.

Buddy Club Dual Bend Short Shifter




Project Kics Kyokugen Lug Nuts 42mm



OE Honda Hood Latch
 
You must log in or register to reply here.
Top