Blacking out emblems

Green4cyl

New Member
My front emblem A is blacked out and i want to make the back ones match so i was wondering if anybody has a guide to doing that thanks for the help
 

DC Guardian

Uniqueness defines
Yank it

No u might snap it lol just wiggle it, theres two prongs in the middle, try to get ur finger or gentle screw driver n lift it

Sent from my DC4
 


dlo253

Active Member
No. You need some double stick tape. Unless you pull the panels in the hatch to access the back of the emblems to take the clips off. But who really wants to go thru all that bs when you can just get some 3m tape like everybody else does haha
 


XjoEnX

Active Member
No. You need some double stick tape. Unless you pull the panels in the hatch to access the back of the emblems to take the clips off. But who really wants to go thru all that bs when you can just get some 3m tape like everybody else does haha
Yup. Spray it it with Goo-gone and let it soak for a bit then get dental floss and start flossing away at the emblem, while spraying goo-gone as you eat through the tape.
 

DC Guardian

Uniqueness defines
One day i took my rear out by mistake, oops, and popped it back in. Didnt fall out or anything. DC > DA :p lol

Sent from my DC4
 

dlo253

Active Member
Odd. Considering the holes are the same lol. Hell no! If it weren't for the lovely DA there would be no DC!! Lol.
 

Green4cyl

New Member
they are soaking in bleach will be painted later tonight post pictures when they are back on in the morning thanks guys and girls if you are out there!
 
Top