Mishimoto Rad Install & Bleed

1992integragsr

jdm92teggsr
Own a 92integra gsr, have bought used Mishimoto rad with blox racing fan,
I know how to install rad and slim fan but need alittle information on how to properly
bleed the rad (get rid of air bubbles) once installed in vehicle. Also need to know exactly what coolant to use with my vehicle
Integra has had a B18c type-r swap and am in need of knowing following info above
 

dlo253

Active Member
That's been covered recently, may find it if you search.
Fill up radiator. Turn heat to full blast. Then pull the radiator cap off. Start car. Loosen bleeder screw until coolant comes out then tighten it. That's just about it give or take a little lol. Just use a coolant that works with aluminum radiators. Mix it 50/50.
 

XjoEnX

Active Member
You should PM member superhypered. He has experience with installing the mishimoto radiator.
 

Samurai_Blue

Yolo Whippin'
once its empty, you can just fill it up with the prestone stuff and let it cycle until the fans come on once, then after the fans shut off, turn the heater on full blast and let it cycle through agaain until the fans come on a second time, once they turn off again, you are done. you want to circulate through the heater core as well.
 


OGstackadoIIa

TEAM LlGHTSPEED RACING
Lmao, didn't he install the fans backwards or some shit?
 


You must log in or register to reply here.
Top