Turbo kit part swapping

[DOLCECULLO]

http://www.timereactioninc.com/acura-integra-type-9401-turbo-p-479.html

If i were to buy this kit, would i be able to keep the piping and lines and swap out the turbo and intercooler? Or would that just be a waste of money?

 

[mirrorimg]

Shop around. If you can spend less than $800 for all the piping, blow off valve, manifold, wastegate, etc, then find it elsewhere. As long as the turbo you buy to replace the one in the kit can bolt up to your manifold youre fine.

You're pretty much asking if the piping is worth the price of the kit, which I dont think it is. You could always shop around for used piping, or having individual pieces made.

 

[hollowfox]

home depot has that piping lol

 

[GSROWNSU]

I would consider that kit (no matter what you do with it) a waste of money. You can get a nice ic piping kit with t-bolts, bead rolled ends, 3 ply couplers, and a flange for the bov of your choice for a little under $200.00. All of those "ebay" kits are junk. With forced induction do it right one time or do it all over again.

 

[DOLCECULLO]

I would consider that kit (no matter what you do with it) a waste of money. You can get a nice ic piping kit with t-bolts, bead rolled ends, 3 ply couplers, and a flange for the bov of your choice for a little under $200.00. All of those "ebay" kits are junk. With forced induction do it right one time or do it all over again.

Do you know of a specific place that sells those? If not i can do a little research