Sleeving a block

konerri

New Member
Ok i was thinking about turbo honda lately after my friend ask me a question? Should you turbo a B-series past 10 psi on 9a pump gas @ 10.0 comp ration. I said, it would be iffy. You should get it sleeved. Then you ask by who would be in the best person/company to use?

i thought for a little and told him...golden eagle. Then he said why? because i couldn't think of any one else at the time. Any other reputable companies out there you might recommend. Like i said i was an all-motor guy.
 

BigMac88

Fat guy in a little 'teg
Darton makes nice sleeves too. Stock sleeves are good well into the 300 whp range, if not even for 400 whp. The first internals upgrade you should do when going turbo is get your block honed, then get forged pistons and rods. Unless you plan on making 400 whp + I think your stock sleeves will be fine.
 
Last edited:

dc2GS-R

Super Moderator
Darton and Golden Eagle both make good sleeves. Personally, I went with AEBS sleeves for B18C1 build
 
You must log in or register to reply here.
Top