db_r
!ocsic
Ok, for all those Skunk2 Pro Coilover owners, how do you manage to lower your car?
I found this following information:
I dont know if that specifically applies to S2 Pro Coil's only, but yeah.
The front springs are stiffer than the rear.
Always adjust the front springs 2 to 3 threads less than the rear in order to
get the car leveled.
About 2 inch drop
--------------------
Rear 19 Threads
Front 17 Threads
Count from the first thread at the bottom all the way
up to the thread below the first ring.
To lock the rings, twist the rings opposite to each other to lock them.
Do not over tighten.
Questions:
Mine are a bit dirty, What can I clean it off with ?
and after I clean them,
How do I unlock them ?:???:
thanks
I found this following information:
I dont know if that specifically applies to S2 Pro Coil's only, but yeah.
The front springs are stiffer than the rear.
Always adjust the front springs 2 to 3 threads less than the rear in order to
get the car leveled.
About 2 inch drop
--------------------
Rear 19 Threads
Front 17 Threads
Count from the first thread at the bottom all the way
up to the thread below the first ring.
To lock the rings, twist the rings opposite to each other to lock them.
Do not over tighten.
Questions:
Mine are a bit dirty, What can I clean it off with ?
and after I clean them,
How do I unlock them ?:???:
thanks