Skunk2 not performing...

lowazzteg

3rd Super Mario Bro
I bought a Skunk2 front camber kit for my db1 and everything was all fine and dandy until I started hearing a clicking when I braked or when I turn my wheels at a dead stop. A nut from each side of the arm (one from driver and one from passenger) just came off. I torqued the sons of bitches down HARD. So after figuring that out, I brought it to my local performance shop to have them PROFESSIONALLY put on 2 nuts. Again, they come off. I paid almost $150 MORE for Skunk2 because I didn't want this shit happening. Someone please explain to me what is going on.

I tried contacting Skunk2's customer service line today but got an instant voicemail so I just left my name and number... :roll:
 

j13

Keep It Clean
ANYTHING suspension must have some type of thread locker or real Loctite.
 


lowazzteg

3rd Super Mario Bro
Used lock washers both times.

But you're saying I should use something else on top of that then...
 
Last edited:

j13

Keep It Clean
Take off the bolt. Put some type of thread lock on the threads, put the bolt on, tighten them good. See what happens.
 

Mr.Yummies

Trade Whore
Would you say your car Vibrates more then others?

Something has to cause the bolts to back out.

Try some loctite like the other guys are saying and go from there.
 


emd513

New Member
loctite. theres nothing else to say. i used it on my header where i loss 6 nuts in a week. put that shit on and it never happen again been like that for 3 months now. i redline my car several times a day.
 
You must log in or register to reply here.
Top