rewired signal lights

92_JDM

New Member
hey guys, i wanted to rewired my signal light and bumper light so it flashes the same time.
but im not really good with wires, but i am able to to do it step by step?
if it is possible, pictures with step would help out a lot.
 

jcrabb13

Registered Abuser
Wires are actually alot easier than you think, get something to strip the wires with and some electrical tape, cut one of the signal light wires and one of the bumper light wires. Twist the end of the bumper light wire (the one still attached to the light) with the two ends of the cut signal light wire. Repeat with the other wires. Before you tape everything up make sure you test your work! once it works like you want it to tape the three parts twisted together, and then the other set of three. and then tape the whole thing for shits and giggles. This will work for what you want, if you have any questions feel free to PM me, pops and grandpa were electricians so I would consider this one of my stronger areas. I'd take some pictures but I have a G3, so your SOL from me. haha
 

DagoAcura92

New Member
jcrabb13 said:
get something to strip the wires with and some electrical tape, tape the three parts twisted together, and then the other set of three. and then tape the whole thing for shits and giggles. pops and grandpa were electricians so I would consider this one of my stronger areas.
Click to expand...
hahahahahahaha. man, u need better tools and parts to say thats one of ur stronger areas. Auto electricians don't twist wires together and then tape it. A car has lots of vibrations, even if u use a whole roll of tape, it will come apart or corode.

Op u need crimp connectors ( not twist on caps ) and a crimper to splice wires together.
 

92_JDM

New Member
well on the solder and heat shrink..how can i get it, is it being sold at
auto shops such as kragen and autozone or do i have to order the parts.
 
You must log in or register to reply here.
Top