burgerpimp07
New Member
My speaker mounting diameter is roughly 5 3/4". Am I going to have to sand off the metal/plastic opening an extra half inch? What bit would I need to use on my power drill to remove that 1/2"?
The front ones went in ok because I used a spacer, and by the time the speaker got to the door panel it fit fine.
***Also, the speaker cover is already pretty close to the factory speaker already when installed. My new speaker has a 3/4" dome tweeter that sticks out a little. ???
Thanks!
The front ones went in ok because I used a spacer, and by the time the speaker got to the door panel it fit fine.
***Also, the speaker cover is already pretty close to the factory speaker already when installed. My new speaker has a 3/4" dome tweeter that sticks out a little. ???
Thanks!