Oil lines??

GSROWNSU

New Member
hey guys i was just wondering about the oil line that goes to the turbo. I know that the oil return line just goes right into the oil pan but what about the oil feed line. I know it's connected to the turbo to keep everything lubed up but where do you connect the oil feed line to the motor? where do you have to tap into get the oil pumped all the way up to the turbo??
 

slow_99integra

Stinkin & Drinkin
ok here goes....
your oil sensor port on the back of your block. you must "T" it off and run a line from there to the turbo. i would recomend stainless steel lines. it should be somewhat directly above the oil filter. this is the spot people run oil pressure gauges from

Or this is a little easier:
Endyn has a plate that goes in front of the oil filter. its job is to run more oil to the head for vtec. you could modify this and run it to a turbo found here http://www.theoldone.com/components/Oil Adapter/generic_oil_plumbing_kit.htm
 

GSROWNSU

New Member
THANK YOIU FINALLY!!! lol i was hoppin someone would answer my question
 


dc2GS-R

Super Moderator
sorry. i've been gone also. i'm back now. i just re-did all my lines and hoses on my gst trying to get some maintenance done before i mod it. braided stainless steel lines work great. you can also you threaded hard lines if you have the little pipe bender to make them the correct shape. just T the feed line off like slow said and you should be fine. might as well run an oil pressure gauuge while you're down there.
 


slow_99integra

Stinkin & Drinkin
GSROWNSU said:
what happened in the hospital...u ok?
Click to expand...
still have that fucking knee problem, and now the problem has manifested itself into my ankle. had to get some tests done, get my ankle drained and a shot of crtisone. tomorrow i should be good. i was on crutches and a serious limp. But not today woot! woot!
 
You must log in or register to reply here.
Top