SupersonicGSR99
New Member
so i picked up a nos intimidator purge kit for cheap money but what do i need to turn it into a dry kit? any help would be nice.
nos intimidator to dry shot
- Thread starter SupersonicGSR99
- Start date
mteg
Automatic Lover
Really all you need 1/8" braided line (I think thats the size) is a shark nozzle with a jet. How are you planning on tuning your car? You'll need a safc at the very least or you'll lean out. Plus to tune you'll need a wideband. The most I would do on a dry setup would be a 35 shot. I would just keep it and incorporate it in a wet setup. Did this setup come with a tank? If not, you need that and the 1/4 hose that runs from the tank to the solenoid. Depending on what came with the kti you will also need a arming switch (besides the push button), misc wires, a 20 amp fuse (for car safety), teflon paste, and misc connectors.
SupersonicGSR99
New Member
I have the bottle, steel braided line, solenoid, relay and fuse, push button switch you know just the purge setup. i heard you can just run a copper line from the solenoid into your intake and it would be a dry lol.
mteg
Automatic Lover
LOL, only if you want to blow the welds on your intake! Seriously, that copper tube for a purge kit would deliver around a 300hp shot. If you look at the jets, they are super small, around the size of a needle point (not the dia. of the whole needle). What you need is another braided line that goes to a shark nozzle. between the nozzle and the braided line is a small jet. I would go with a 35-no larger than 50 unless you are tuning. The shark nozzle just gets installed infront of the tb on the intake side spraying in. Good luck