no power to starter selenoid

[pedalkornet]

Hey every1 im new to CI i just have this problem with my starter wires and i seem to not be getting power to the selenoid i replaced the starter relay but still no power can some1 heeeelp by the way its a 90 teggy thanks

 

[The Kev]

Have you checked the entire ignition system? Might have to replace the cap and rotor, most likely the problem is always there...

 

[dlo253]

What exactly happens? This should also be in the gen2 section.

 

[pedalkornet]

I checked intire ignition even replaced it but no sound no click nothing

 

[Swerve]

Bang on that sheeit they get stuck easy after awile

 

[dlo253]

Well if it does nothing chances are its a starter issue of some sort, or power/ground issue. Do your dash lights come on? Double check all grounds and make sure they are good.

 

[pedalkornet]

Yup dash lights come on and all grounds are nice and tight,ive got power from ignition to relay but from relay to starter nothing tried 3 different relays too.

 

[dlo253]

Are they grounded on bare metal?. See if you can get it to do anything by touching a wire to the pin connector and positive battery terminal. Make sure the car is in neutral, obviously.

 

[jbrown97ls]

Definitely make sure all your grounds are getting good contact. I trouble shot for 4 days of my car not starting for it to be a little bit of paint on the tranny bracket.

 

[pedalkornet]

Yea it starts if i run power directly to the starter