Need some advice on ls build

boostedteggy90

New Member
I recently bought another ls motor to build this winter, my goal is 300-320 whp with a t3/t4 turbo setup

Does anybody have any reccomendations on what i should do as far as my build goes?

I was thinking pistons/rods, polished crank, and keep everything else stock and just rebuild it.

thanks
 
Last edited:

Rich-PMS

New Member
I'd do rods, pistons, cams, tune.

Plus allthe fun machine work
 


00GSRfullbuild

New Member
lol im pretty sure when he said i want 300-320 on a t3/t4 is boost. Anyways, yea make sure you get head studs, and a good manifold for turbo. Like the edlebrock victor x. Skunk2 is ok, but kinda pricey for not doing a lot. Just make sure you have a nice tune

You didnt say if it was LS/vtec or just ls. That makes a differance, if its not vtec dont worry about cams and stuff. Just build the bottom end. You may want to consider a vtec head eventually and then build that with your built block, run 8-9 pounds all day n deff make well over 300.
 

00GSRfullbuild

New Member
They have a N/A manifold too, are you sure thats not the one for high rev? Cuz it actually has longer runners than the victor, from there site it said victor is your best beat for boost. I could be wrong though.

I sold my Skunk for a victor and have been very happy with the differance tbh...
 


You must log in or register to reply here.
Top