Need help with a pic? Anyone plz?

[Jamesm803]

I have a 93 integra. Just put trans in and linkages don't seem right. I put the car in first gear, and I can shake it like its in neutral. Is there a bracket to hold #1 rod from twisting. It rotates about 40 degrees and I was told it wasn't suppose to do that but I don't remember a bracket or clip? Help. If u have a 93 teggy can u post a pic on this thread showing the full mount and how there suppose to be plz?????? Much appreciated.

 

[C uR eX]

Well you got 2 rod/linkage, the Shifter goes into the tranny and is hold in place with a pin (aka b**** pin) and the other stabilizing rod/linkage with the forward end slide over the side of the tranny and is held with a washer/plate and 12mm bolt. At the end where the shifter is has a bushing and metal plate that is held up with 2 12mm or 10mm bolts. That's all there is to it, not sure what else is there. Hope i make sense...
But if i'm reading your post correctly it seem like you're referring to the shift linkage and not the tranny mounts, correct?

http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=CIVIC&catcgry2=1991&catcgry3=3DR+SI&catcgry4=KA5MT&catcgry5=SHIFT+LEVER

 

[Jamesm803]

Yea shift linkage. The side rod that mounts onto the side of the tranny twists. I'm assuming there a bracket to keep it from twisting