n2o on b20b vtec with stock internals ?
- Thread starter 7650
- Start date
Integraguy04
CORNER CARVER
u can...but b20 sleeves are pretty thin...just an fyi
patrick4588
Integra God
honestly a 75 shot will be fine. just pull 2 degrees of timing and use a wet kit. nitrous kits are pretty safe nowadays when used properly.
Campanelli
OMG it has VTEC?
Did you buy this car built?
7650
New Member
@ dc2b18
engine was completely built with the help of B20b vtec conversion manual available on net. and according to me its not that hard swap. But the main thing is i m running it on Stock ECU, and on b16 stock rev limit. thats where i have bad thoughts.
@ patrick4588
Got your point mate, I'll keep that in mind when installing n2o but the main thing i am worried about is rev limit.
@ Campanell
I recently built this Car.
@ Topic
guys the other problem i m facing is i read about this frank swap like alot. but frankly i m not getting the expected results, is it because i m using Stock ECU with b16 fueling and maps on 2.0 motor? help and advice needed.
Thanks
engine was completely built with the help of B20b vtec conversion manual available on net. and according to me its not that hard swap. But the main thing is i m running it on Stock ECU, and on b16 stock rev limit. thats where i have bad thoughts.
@ patrick4588
Got your point mate, I'll keep that in mind when installing n2o but the main thing i am worried about is rev limit.
@ Campanell
I recently built this Car.
@ Topic
guys the other problem i m facing is i read about this frank swap like alot. but frankly i m not getting the expected results, is it because i m using Stock ECU with b16 fueling and maps on 2.0 motor? help and advice needed.
Thanks
patrick4588
Integra God
tuning makes a big difference. if you arent tuned, then you wont see maximum results. id spend your nitrous money on a nice engine management system and get nitrous later.