My teg + bolt problems?

89teg

New Member
I'm new here so I thought i should post about my teg and ask a quick question while I'm at it. I recently bought my 89 integra ls for 600$. It would start but made horrable rcquet. All I had to do was fix the valve lash. I set it to .005, is this right? Anyway. The interior of the car I's almost "perfect" except for a stain on drivers seat. Radio works when it wants. Sunroof need new motor/seals. Suppost rods for trunk dont work. The only things left till it runs right are a new tps & I think I'm going to get a new intake. I have a exhaust a friend previously used on his teg but I can't get the bolts off of my original exhaust. How could I go about doing this?








Sorry for bad spelling or if images don't show, I'm on my iPhone.
 
Last edited:

89teg

New Member
Tam4511 said:
Thats a clean ass g1 good find and good luck!
Click to expand...
Thanks. I thought I got a pretty descent car, this is my first car
so it should be an experance.

I just put on some pb, wd-40 did nothing! If this doesn't work going to have to resort to cutting them off which I'm half tempted to do it already.
 
Last edited:

Holmes Alex

New Member
Try soaking the bolt in solvent. Sounds like the firing pin is gummed up. If that doesn't do it, take it to a gunsmith.
 


You must log in or register to reply here.
Top