lowANDslowDA9
New Member
I need new motor mounts in my da. I'm thinking about getTing some inserts. Was wondering if anyone has used them before and if they are worth it.
motor mount inserts
- Thread starter lowANDslowDA9
- Start date
Samurai_Blue
Yolo Whippin'
They stiffen up the car a bit, they are easy to install as long as you have a itr/ls manifold um what else. they are cheap. This all goes in the inference you are using the Energy ones for the back and the two torque mounds. The prothene inserts are dummy stiff
BrokenTalon27
W.F.O
You shouldn't add mount inserts to broken mounts. I don't think inserts are available for the G2 chassis that replace the entire mount's rubber, they just fill in the gaps.
lowANDslowDA9
New Member
Yeah I was going to. I know it's a hell of alot cheaper than just buying one motor mount.They stiffen up the car a bit, they are easy to install as long as you have a itr/ls manifold um what else. they are cheap. This all goes in the inference you are using the Energy ones for the back and the two torque mounds. The prothene inserts are dummy stiff
lowANDslowDA9
New Member
That the prob I have is my top mount is toast.You shouldn't add mount inserts to broken mounts. I don't think inserts are available for the G2 chassis that replace the entire mount's rubber, they just fill in the gaps.
Samurai_Blue
Yolo Whippin'
prothaneYou shouldn't add mount inserts to broken mounts. I don't think inserts are available for the G2 chassis that replace the entire mount's rubber, they just fill in the gaps.
BrokenTalon27
W.F.O
I just looked at the kit Dylan, it only fills the gaps that the OEM mounts have.prothane
OP, you need a new mount if that is the case.
Last edited:
lowANDslowDA9
New Member
I found a set on Ebay that fill the whole mount. They are like 55$.I'll have to check them out. When I was searching for inserts for my DB1 I could only find the inserts that fill the gap.
BrokenTalon27
W.F.O
Link please.I found a set on Ebay that fill the whole mount. They are like 55$.
Samurai_Blue
Yolo Whippin'
depends on the mount. The driver upper replaces the entire rubber. The upper tranny fills the gaps but its enough to where a ripped section becomes stronger. Those mounds are pretty damn stiff.I just looked at the kit Dylan, it only fills the gaps that the OEM mounts have.
OP, you need a new mount if that is the case.
Samurai_Blue
Yolo Whippin'
that does the upper driver side maybe the rear and maybe the tranny. Your car will be dummy stiff...one of your upper mounts is bad i would probably find a new or used one...especially if its a street driven car.
lowANDslowDA9
New Member
I got a mount on trade. And come to find out out was a ef mount. It's hard to find used parts for a DA in Ohio.
Samurai_Blue
Yolo Whippin'
junk yard?
lowANDslowDA9
New Member
Off topic how do you post pics on here