metal band holding the ac evaporator is dripping water

[jenktj93]

on my 93 integra i noticed in the far right corner on the passenger side floor that its wet just below the ecu. the band that is under a black box (ac evaporator) is orange (rust) and dripping water slowly. but its only wet and dripping when its raining outside and its just in that spot anyone know what this could be

 

[BigMac88]

A leak :what:

 

[mirrorimg]

I believe on Second Gens, there is an issue with the cowl that the clips that seal it leak, allowing water down into that portion of the floorboard. If it only happens when it rains, then that is the problem, not a leaky strap.

Im sure you will find more information on what need to be fixed to correct the problem. If you cant locate it by the time I get home this evening, I will pull it up for you. I do recommend you do the searching though.

 

[jenktj93]

i noticed a space between the plastic cover near the lower part of the windshield. it has a few whit plastic things in sticking out of the holes. its right where the wipers rest but n the plastic things its looks like thread for screws but none were present when i purchased the car. i can stick my pinky in the space of the lower part of the windshield and the plastic cover maybe that shouldnt have a space?

 

[macdman]

ya i have the same problem with my integra i cant figure it out

 

[mirrorimg]

Send me a PM to remind me to come looking for this thread this evening. I will pull up the information for you.

 

[jenktj93]

i think this problem is becoming a serious one. first of all my ac fan doesnt turn on until i put it on speed 3 or 4. i believe that is the resistor. correct me if im wrong . but when i turn it on the cold air doesnt work. it use to in march . now it doest get cold . and the thing makes like a light screeching noise sometimes. it sounds like its coming from the glove area

 

[mirrorimg]

http://www.honda-tech.com/showthread.php?t=2548435
http://www.g2ic.com/forums/showthread.php?t=192639
http://www.clubintegra.com/board/showthread.php?p=44279
http://g2ic.com/tegtips/interior/15.html

I think some of these links share the same information. Hope this helps.

As for the fan not working until more power is sent to it at a higher setting, it could be that the moisture has led to the corrosion and rusting of the blower motor. Does it only happen when the AC button is depressed? Does it happen no matter what heat setting is selected?