ITR swap, 1996 Teg exhaust fit?

[Globelparadise]

Sorry to change the subject but Ive found some exaust for a 96 to98 integra but I own a 1990 integra about to have a type r motor installed. does it matter what exaust i use?

 

[Samurai_Blue]

Sorry to change the subject but Ive found some exaust for a 96 to98 integra but I own a 1990 integra about to have a type r motor installed. does it matter what exaust i use?

spam?

 

[TegSox]

No spam, moved from another thread.

 

[Samurai_Blue]

Sorry to change the subject but Ive found some exaust for a 96 to98 integra but I own a 1990 integra about to have a type r motor installed. does it matter what exaust i use?

you can only use an integra exhaust from a 90-93 i think

No spam, moved from another thread.

:thumbs up for sure

 

[Jabes]

unless you have traction bars on a da you cant use a 4-1 integra header

 

[Globelparadise]

do you know if a 96 to 98 b18 type r motor will just bolt in or do I have to get different motor mounts?

 

[Samurai_Blue]

its direct bolt up

 

[JDMxDB8]

Sorry to change the subject but Ive found some exaust for a 96 to98 integra but I own a 1990 integra about to have a type r motor installed. does it matter what exaust i use?

You have to use an exhaust for a 90-93 Integra.

 

[BrokenTalon27]

You have to use an exhaust for a 90-93 Integra.

It also has to be hatch back or sedan specific. You can use a DA exhaust on a DB1 and vice versa.

 

[Globelparadise]

ya its a 2dr integra.

 

[BrokenTalon27]

Shouldn't be hard to find an exhaust for it then. If you're going to have an ITR motor, I would do like mentioned above and get a traction bar so you can run an ITR header or something with a 2.5" collector and go 2.5 all the way back.

 

[Mildsquare]

you can use a DC2/DC4 94-01 integra axle back exhaust depending on the muffler/canister size, it till take some modification but it will fit, I wouldn't recommend it because most look funky and and are rather bulky unless it's a fart cannon that's skinny.
You can Run a 4-1 header on a 90-93 integra, you either have to run a traction bar or notch the front cross member to allow clearance. when notching people usually cut way too much in order for it to fit.mine is barley notched as where my buddies has a section missing.

 

[JDMxDB8]

Shouldn't be hard to find an exhaust for it then. If you're going to have an ITR motor, I would do like mentioned above and get a traction bar so you can run an ITR header or something with a 2.5" collector and go 2.5 all the way back.

I think 2.5" on a stock ITR is a bit overkill. 2.36" should be perfect.

 

[BrokenTalon27]

I think 2.5" on a stock ITR is a bit overkill. 2.36" should be perfect.

You're probably right.