boricua_ls
New Member
iam halfing trobule my half shaft aint alining with the block so that the bolts can go in what might be going on do i got to bang it in with a hammer or plz help thanks
Is the half shaft on DAs the same as in DCs
- Thread starter boricua_ls
- Start date
BrokenTalon27
W.F.O
No. They are different, as mentioned above. You can however run a DC driver axle and half shaft on a DA if you can modify the half shaft to bolt up.
boricua_ls
New Member
well my motor is from a dc but its not hydro previous owner keept it cable so they told me i cant use dc half shaft cuz thats for hydro but this car waz auto made to manuel but for some reason the old half shaft wont aling with the bolt holes and i got two half shafts and nun of them aling with the bolt holes on the tranny and iam not suapose to hammer it in either they told me its suapose to be a easy fit
boricua_ls
New Member
and the motor i half is a b18b1 but its cable not hydro so they told me i cant use the dc half shaft cuz its for hydro only