Integra seats, options?

[96tegse]

i have a 96 integra and im looking to put seats in it. what seats should i put in it. are they any stock seats that would fit

 

[Teggy64]

Any 94-01 integra seat, civic, and I think del sol seats as well.

 

[Merlins Beard]

I prefer the OEM Integra seats, civic seats to me look bad. Shouldn't be too hard to find some seats from a part-out or at a junkyard. What is wrong with the seats in your car? (if there are seats in your car)

 

[Samurai_Blue]

i like integra seats over s2k seats. S2k seats were uncomfortable for me

 

[Merlins Beard]

If you wanted to, you could use/modify almost any seats to fit into your car, just depends on how much work/money you are willing to spend. You can change seat rails and mounting brackets to make almost any seats fit if you wanted to.

 

[Samurai_Blue]

changing the seat pans works on most Honda seats. Not sure about the DC5 but it works on Del Sol, EG, DC, and S2k from my experience

 

[96tegse]

i dont have any seats in mine right now ha

 

[DC4GoFast]

Try and get some seats from a 4th gen prelude (92-96) Most comfortable seats EVER. I love em.

 

[OGstackadoIIa]

I have Eg seats in mine, I think they set lower; not too bad. I like the single pillar design because you can get your hand behind a bitches neck a lot easier when she acts a hoe

 

[NastyDB8]

I have Eg seats in mine, I think they set lower; not too bad. I like the single pillar design because you can get your hand behind a b****es neck a lot easier when she acts a hoe

lmao!!

I have Del Sol front seats in my 96' DB8 ; )

 

[dlo253]

gsr leathers.

 

[NastyDB8]

gsr leathers.

Yup I got those in the rear in tan ; )

 

[dlo253]

Nice, then i vote matching fronts... lol.

 

[HobbesVT]

I just ganked 94 prelude seats from the junkyard for my 2nd gen. Needed a bit of modification because I have the auto shoulder belt that has it's spool/coil thingy on the inboard part of the lower seat. I hate auto seats. Anyway I didn't swap brackets. 3 of the 4 holes lined up, so I will tap drill and tap the rear outboard hole for it. I ended up removing the buckle from the lude seats and installing the shoulder belt spool/coil thingy on it. Granted the 2nd gen uses two 6mm bolts to affix it to the seat, the prelude has a 10mm mounting post that I used. If I wanted to do it perfectly I would of fabed a bracket to affix both points the lude seat but I figure the cross section of the 10mm bolt is actually stronger than the two 6mm bolts combined. It worked for the lude, so it worked for the teg. I have the passenger's in, if anyone wants picks say so, because I have yet to do the driver's side.