intake cam off

Nupraptor

New Member
So had to put in a new head gasket, once complete car wouldn't start so went to check timing and the belt slipped on the intake cam. The exhaust cam is still in the right place but the intake cam is off by 180 degrees. My questions are can I just take the cam out and reinstall it and the timing belt or do I have to worry about the cam being bent or it causing damage to the valves and piston?:(
 

Jvest

*GET SHOOK*
Take the belt off and line everything up correctly and then rotate the motor by hand to make sure nothing is hitting. If it is it will be noticeable.
Make sure once u get the belt on you rotate the motor at least 2 full turns by hand and check the tension on the belt before u try to start it.
Good luck
 
You must log in or register to reply here.
Top