How do you fix this ????

300zxkid

New Member
Now what ????

My integra is giving me a code 13 Barometric Pressure. She runs and stalls misses at idle and the repair manual said to bring to dealer service or repair shop. Now i would like to fix it myself so any help from here would be great thank you
 
Last edited:

300zxkid

New Member
Car still stalls if your driving at 4omph and shes stalls then kicks back on. Or if your stoped and shes stalls it takes some time to start her back up. I know she is getting gas i can smell it and the tack still got a flux. By that i meen tne motor stays at the same speed but the tack jumps!!!!
 


jdmjim

nothing from nowhere
check for a vacum leak but it sounds like your loosing ignition, check your dixxy and ignitor, look for loose wires in there
 

300zxkid

New Member
Dizzy got less then 8000 miles on it. I tryed starting it today she fired up and stalled tryed again starter just spined not turning the flywheel. The tack jump to redline without the motor running with the starter spining??????
 


jdmjim

nothing from nowhere
look inside it though, i had one the wires were left loose from whoever rebuilt it
 

300zxkid

New Member
Ok just put in a new coil and its doing the same thing wtf. Could it be a short in the starter or alt or injectors ????
 

hidenplanvew

New Member
I had something similer and changing the coil fixed it... Did you buy the dizzy from somewhere local.. AUTOZONE or NAPA or something? Do you know any one with a good dizzy that would be a way to find out if the dizzy was bad. Possible ECU problem or wire problem, or vac leak (use carb cleaner around the intake gasket and where vac could possible leak) if there is a leak it might smoke alittle out the exhaust or it will try and die. Those are the 3 things I would try first and knock them out and if it still happens let me know
 
You must log in or register to reply here.
Top