help

[1.8l_dohc_92]

so i was fixing my timing once again...
and i noticed that i have a gap between my engine block and my crank pulley
is that good? bad?

 

[DaddyBuiltRacing]

Its normal, theres a timing gear that sits between the crank pulley and the block anyways. Your belt goes around it...

Look at part number 11

http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=CIVIC&catcgry2=2000&catcgry3=2DR+SI&catcgry4=KA5MT&catcgry5=CRANKSHAFT+-+PISTON

 

[1.8l_dohc_92]

yea its in there but theres a gap between that part and the engine block
this video is of my car not starting
http://www.youtube.com/watch?v=il1pXmrPcaI

 

[DaddyBuiltRacing]

Is it just me or is the firing order wrong on the plugs

It should be
3 4
1 2

To me it looks like you have
4 3
1 2


Also, not sure of your setup but did you by chance swap out to an aftermarket map sensor? If no then disregard. Next make sure your TPS and Map sensor plugs aren't switched, they are identical looking and close to one another.

 

[BrokenTalon27]

Is it just me or is the firing order wrong on the plugs

It should be
3 4
1 2

To me it looks like you have
4 3
1 2


Also, not sure of your setup but did you by chance swap out to an aftermarket map sensor? If no then disregard. Next make sure your TPS and Map sensor plugs aren't switched, they are identical looking and close to one another.

I wondered the same thing but couldn't tell from the video quality.

 

[1.8l_dohc_92]

firing order is correct and my tps and map sensors are in the correct position

 

[BrokenTalon27]

Have you checked to make sure you're getting fuel and spark?

 

[1.8l_dohc_92]

yea i have both fuel and spark but ive noticed that the fuel doesnt ignite therefore i dont have combustion its good gas and idk what it could be

 

[DaddyBuiltRacing]

Hmm...must be the camera you used cause firing order definitley looks wrong. You obviously have a camera, wanna do me a favor? Take a video of you running your hand from the number one spark plug hole to the spot you have the wire hooked up on the cap. Not trying to under-estimate your knowledge but again from that vid it looks like the order is off, which would explain why its not firing.

I know you said you checked timing again, but if its off even a tooth, sometimes it wont start and will sound like lack of combustion.

 

[1.8l_dohc_92]

koo ill do that today and ill post up today