heater control cable is stuck

blackbear1990

New Member
ok im new here first post always reading on here iv had my 94 integra ls for a wile i just did this thing i found on here took my rear motor mount out was broken filled it with polyurethane caulking i got from the home depot as i was doing this took my heater control valve 10mm bolt off to move the bracket out of my way just so it was sitting there put everything back and now my heater cable is stuck on cold i cant move it???? i took my climate control center dash off just to look but it still wont budge i need help?? heater worked perfect befor this i dont drive my car much because i just got a new 2001 zx6r but i love my car so i need help to fix her my girlfriend hates how cold my car is now


lol a lil bit about my integra i have approx 250k miles aem v2 intake dc sport 4-2-1 1peace from my last b16 civic i had test pipe cause had to change the flange angel and because my cat was bad took my power steering out and also took my a/c out some hid's and that's it ha i plan to keep this car iv always wanted a integra like forever....
 

emd513

New Member
It's like a cable on your bike. If you move it and then tighten it down in the wrong position you can only go one direction with it. And that is probably right at the stopper of the switch. Chase it down make sure you didn't loosen the nut for it.

Sent from my DROID RAZR using Tapatalk 2
 

blackbear1990

New Member
i also tried leaving it loose and still the cable seems like its stuck from behind the fire wall the inside of the car somewhere i look under on the inside and idk anthing about the weird plastic thing with like four cables....
 


You must log in or register to reply here.
Top